Cylindrical Ring
Direction of Tolerances: Gages - tolerance is applied minus on the "GO" member, plus on the "NOGO" member - unless otherwise specified; Masters - tolerance is applied bilaterally. --------------------------------------------------------------------------- Entry Radii Both ends, .010" (.25mm) to .015" (.38mm). --------------------------------------------------------------------------- Handle Prices Include a collet (two collets if double-ended) and bushings for the gage elements ordered. --------------------------------------------------------------------------- Gage Marking Customer part number, "GO" or "NOGO" dimensions, and gage tolerance class - XXX, XX, X, Y or Z. Customer part identification is engraved on the body; the "GO", "NOGO" label, diameter and tolerance class is engraved on the face of the steel jacket for gages with diameters less than 2.00 inches. For gages 2.00" and larger in diameter, the identification is etched on the face of the carbide near the outer diameter. Included as standard in the price of the gage. GLE standard "NOGO" gages also are physically identified by a groove which encircles the OD of the jacket, centered on the gage length, and the length of sizes .366" (9.30mm) to 1.510" (38.35mm) is approximately half that of a GO gage. --------------------------------------------------------------------------- Design For diameters less than 2.00" (50.8mm), a heavy walled carbide ring protected by an outer jacket of knurled steel. For diameters 2.00" or greater, the carbide insert is protected by a jacket of a special nylon material - which thermally insulates the carbide from handling and is 1/7 the weight of steel. Ring gages for "NOGO" applications from .366" (9.30mm) to 1.510" (38.35mm) in diameter are available with smaller gage lengths. | 
